I’m sure some of you might be wondering if I’m ever going to follow-up with a post about the felted bag I had worked on over the summer. Well…I finished it! Yay!
After I completed the needle-felting process a few months ago, the bag sat in a corner of my bedroom as life sped up around it. At one point, I sewed the zipper along the top edge. On another day, I added the feet to the bottom of the bag. And then I had to sew the handle rings to the outside of the bag. This part—the handles and how they’re attached—is where I will probably change things when/if I make another one of these bags. To offer a woman such a nice big bag (and it is big!) with such spacious real estate inside just begging to be filled and utilized…and yet to construct it with a weak handle system…well, a bag is only as good as the strength of its handles, right?
In order to give the handles more stability, I sewed through a square piece of fabric on the inside of the bag while sewing the rings to the outside of the bag. That way, when the bag is hanging off my shoulder or dangling from my hands, the weight is not just pulling my felted yarn, but also the piece of fabric (now hidden by the inside liner). It’s amazing the difference that created—because, yes, I attached the first ring without the fabric and my eyes bulged when I saw how it would pull on the sides of the bag!
Here and there throughout the autumn months, I worked on the inside lining of the bag—cutting the fabric, cutting the interfacing (the iron-on kind), cutting the MDF board (for the bottom of the bag), sewing everything together… Mind you, I had no pattern to follow, for a lot of the extra online information one could have found on this bag six years ago is no longer available, so I had to make up my own based on how I knew the bag itself was constructed. In the end, the liner’s girth was an inch or so wider than the interior of the bag—but with a little folding and the help of a curved upholstery needle, I was able to tack the sides of the lining to the bag in four different places with a running stitch from top to bottom. I finished that, along with my little zipper pull, during my daughters’ Christmas break.
Thus, for the past few weeks, I’ve had only the handles to complete. To make those, however (strips of suede cloth wrapped around cotton belting) I needed my sewing machine—which lay under a mound of stuffed snowmen. Last weekend I finally unearthed the machine and joyfully made my two straight-sewn lines (yep, that’s all I needed it for). The incredibly difficult part came after I slid the belting inside the suede cloth sheath—I needed to hand-sew it around the handle rings.
Somehow I managed to sew one side of a handle around the first ring with your run-of-the-mill sewing needle—and also managed not to injure my fingers in the process. Try as I might, however, I could not get that needle to go through the belting and suede cloth for the second ring. So off to Joann’s I went the next day to buy a needle specifically made for working with leather. After that, the sewing went easier. Easier, but not necessarily easy. My middle finger suffered a nice puncture wound from that needle (anyone seen the tip of a leather needle? It’s huge compared to the teeny-tiny points of your average sewing needle!), but thank the Lord for Neosporin. That stuff is amazing at numbing the pain!
And so it was this past Friday, with a fresh Band-Aid swathing my finger and just minutes to spare before having to pick up my girls from school this past Friday, that I finished a project begun around the time school had let out for summer vacation in 2014. 🙂
I’m hoping the bag will be able to come with me when we travel this upcoming summer…since that’s why I set out to make it in the first place. I say “hope,” though, because the thing is bigger than I anticipated and we’ll be traveling by airplane, so I have to wonder: will the flight attendants let me take it into the cabin of the plane?
Because after all the work I’ve put into it, it sure as heck isn’t going into the belly of the plane!